: If a thin part (like hair or a sword) is warped, dip it in hot water for 20 seconds, gently bend it into the correct shape, and hold it under cold water to set. 3. Assembly Sequence For complex figurines, follow this order:
: Use fine-grit sandpaper (400 to 1000 grit) to remove support marks or "seam lines" where the mold halves met. 2. Test Fitting (Dry Fit) VD-TGM0001.rar
: Start by connecting the largest central pieces. : If a thin part (like hair or
: Most VD-TGM models use a "peg and hole" system. Test each connection before applying glue. Test each connection before applying glue
: If the parts were resin printed, ensure they are fully cured and washed. If they are physical resin cast parts, wash them in warm soapy water to remove mold release agents.
: Attach legs to the base (if applicable) and then the arms to the torso.
: Extract the .rar file and compare the parts to the "Parts List" image (usually included as a JPG or PNG in the folder).