Ensure your control method (e.g., V/f Control or Open Loop Vector) supports Speed Search, as some high-precision flux vector modes require specific PG feedback tuning to work.
To ensure the drive catches the motor smoothly without tripping an overcurrent fault, adjust the search sensitivity: Speed searchВ Control v 15.0.2
If you are using a specific software suite (like or Alta Control ) where "v 15.0.2" refers to a firmware version, check the Cisco Bug Search Tool or the Alta Release Notes to see if "Speed Search" refers to a new UI search optimization or performance feature. Ensure your control method (e
Set b3-01 (Speed Search Selection) to 1 (Enabled) . Look for a steady LED indicator or a
Look for a steady LED indicator or a software status bit that confirms the drive is in "Speed Search" mode during startup.
Locate the primary activation parameter in your control interface.
Decide if you want it to trigger automatically after a power loss or every time a "Run" command is given. 2. Configure Current and Timing