Router> enable Router# configure terminal Router(config)# interface gigabitEthernet 0/0 Router(config-if)# ip address 192.168.1.1 255.255.255.0 Router(config-if)# no shutdown Router(config-if)# exit Router(config)# interface gigabitEthernet 0/1 Router(config-if)# ip address 192.168.2.1 255.255.255.0 Router(config-if)# no shutdown Use code with caution. Copied to clipboard Click on PC0 -> Desktop -> IP Configuration .
Copper Straight-Through cables for end devices to switches; Copper Straight-Through for switches to router interfaces. 2. Addressing Table Example configuration for two subnets: IP Address Subnet Mask Default Gateway Router0 192.168.1.1 255.255.255.0 Router0 192.168.2.1 255.255.255.0 PC0 192.168.1.10 255.255.255.0 192.168.1.1 PC1 192.168.2.10 255.255.255.0 192.168.2.1 3. Configuration Steps Router Setup Access the CLI and configure the gateway interfaces: harmadik.pkt
The file (Hungarian for "third.pkt") is typically a Cisco Packet Tracer laboratory exercise used in Hungarian vocational or university networking courses. While the specific requirements vary by school, these labs generally focus on implementing basic routing, switching, and endpoint configuration. While the specific requirements vary by school, these
Below is a generalized write-up for a typical "Harmadik" (Third) Packet Tracer lab based on common curriculum standards. harmadik.pkt